Instal the new for mac Pool Challengers 3D12/13/2023 To start, please ensure that you are using either thumb drive that is formatted in FAT32 or NTFS. Then copy your firmware files that were provided to you, to the root of the thumb drive.įactory default your unit: Go to settings… open the System Information applet and go to Advanced then click on the Factory Default… button. Tested on production 13-inch MacBook Pro systems with Apple M2, 8GB of RAM, 256GB SSD, and prerelease macOS Ventura. Tested with prerelease Safari 16.1 and Chrome v1.125. Once you have factory defaulted your unit, go to Settings… and then Security Settings. Performance will vary based on usage, system configuration, network connection, and other factors. Inside of the Security Settings applet, please check the box next to Enable installation from USB storage, then click the OK button. With this setting enable, please insert your thumb drive into the unit and wait for the prompt to show up. If it is not already on the Firmware Update tab in the left hand pane, please click on that option to switch to that tab. Once there, click on your firmware file to highlight it and then click on the Install button in the lower right hand corner. The unit will proceed with updating the firmware on your device. ![]() This process will take a couple of minutes so please do not power off or remove the thumb drive from the unit during this time. The unit will prompt you that it is going to reboot when it is ready – please click on the OK prompt to proceed.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |